High standard steel frame Adjustable Semi-diameter Arced Concrete
It can be used for any curved wall with the semi-diameter longer
Adjustable acted Formwork Profile
Adjustable Semi-diameter Arced Formwork On the basis of the foreign
company technology, we developed the
Adjustable Semi-diameter Arced Formwork, which can be used for any
curved wall with the semi-diameter
longer than 1.10m. Traditionally, the formwork is produced in
accordance with the designed semi-diameter,
which is one-off use, causing much material wasting. All the
defects of the traditional formworks are overcome
after we developed the Adjustable semi-diameter arced formwork.
Also, we lease the formwork out to the contractors
to save their cost, which proves good effect.
Adjustable acted Formwork's panel is 18mm Plywood,because the panel
specification is 2440×1220 mm,so the formwork
max width is 2440mmUpright rib is combination steel frame ,the
panel and the steel frame is connected by bolt ;
Horizontal rib is short Double-side V-iron , there are adjustable
connectors between V-iron.Upright side-rit is angle steel .
The radius can be regulated at any time when meet to different
section. Adjustable Acted Formwork Technique parameter:
Allowed Load50-70KN/M2 Per square meter65KG
Advantage of the product
Can be adjusted to any curved wall with a semi-diameter longer than
Easy and quick operation.
Low cost and wide use.
High standard elements.
1. Assemble timber beam and timber connector.
2. Assemble plywood and edge rib.
3. Assemble adjustable system.
4. Assemble connecting waling.
5. Adjust the formwork, make the formwork bent into designed
6. Connect every module by adjustable steel clamp.
One plan sketch is shown below