TW905 Penetration Clear Sealer
A Water based exterior penetration sealer for masonry surfaces with
Interior or exterior masonry surfaces.
1. Excellent penetration.
2. Excellent water resistance
3. Excellent alkali resistance.
3. Good adhesion.
*Coverage: Up to 12 square meters per litre once, depending on the
surface porosity, method of applications.
*Thinning: Thinning is prohibited before use, and applied by brush,
roller or spray.
|TW901 Classic Interior
TW902 General Purpose
TW903 Alkali Resistance
TW905 Penetration Clear
TW906 Classic Exterior Primer
|Description||A water based acrylic primer/sealer specially modified to maximize
penetration and adhesion as a primer, and alkali resistance as a
|1. Good adhesion and stability|
2. Excellent covering power
3. Excellent water resistance and alkali resistance.
4. Superior antibacterial formula can kill kinds of bacterium.
5.100% water based paint, low VOC, odorless and environment
6. Easy to apply
|Masonry, cement render, concrete, fibrous cement sheeting, AAC
block and panels and plasterboard.|
|Surfaces to be painted must be solid, clean and dry. Allow
concrete, cement render and mortar to cure for 28 days or until the
alkalinity drops below pH10 before painting. Remove all dirt, dust,
grease and grime. Prime with|
Taubmans primer and allow to dry.
Previously Painted Surface: Remove all loose and flaking paint.
Treat mould with bleach and rinse with water. For previously
painted water-base surfaces, spot prime bare areas with 1coat of
Taubmans primer prior to application of top-coats.
|Coverage||12 m²/L,depending on the surface texture, porosity and the method
|Drying Time||Touch dry: 30 Minutes||Recoat: 2 Hours|
|Note: This may be lengthened in damp, cold or humid conditions. Do
not apply at temperature below 10ºC.|
|Temperature||Avoid application when surface temperature is below 10ºC or above
35ºC and particularly in dry, windy or wet conditions.|
|Stirring||Stir thoroughly before use. To aid in color consistency do not
apply different coating batch numbers to the same surface. Box
pails for final coat, if more than one coat is required.|
|In hot weather, or application by spray, thinning with water up to
5% may aid application.|
|The product can be thinned with up to 20% clean water before use,
and applied by brush, roller or spray.|
Thinning is prohibited before use.
|Application method||Brush, Roller, Spray|