Advantages of pp Formwork
Reuse 60-80 times ,6-8 times than plywood , totaly save cost more
Average weight 8.3kg/square meter ,make the work easily
installation quickly ,save labor cost and shorten the period of
3.High strength,hardness,impact resistance-small check design
Small check design increase the srength , hardness and impact of
resistance ,reduce the weight.Shore Hardness(HD) is 70 .Impact
strength:Lateral pressure is 41.5KJ/m2 ,Vertical pressure is
4.Easy demould and the best effect of casting molding
Smooth and clean surface make the demould easily .No need release
agent ,only tapping then the formwork will fall off .And the effect
of casting molding is very good .Also this finally shorten the
period of project.
5.The best toughness
Can be used to make other different shapes and size
formworks.Bending strength:Lateral pressure 14Mpa , Vertical
pressure 21Mpa .Bending modulus:Lateral pressure 782Mpa ,Vertical
Hollow design make the formwork structural stability .Dimensional
shrinkage under heat:lateral 0.15% Vertical 0.13% .Diffcult
deformation, no mildew; Long-term immersion stratification in the
water, no bubbles, sheet size stability, especially suitable for
underground and damp environment.
7.Acid and alkali resistance, corrosion resistance
Very suitable for the engineering application in coastal areas,
mine, as well as seawall. It is need not do any preservative
treatment both in using and storing the formworks, which do not
pollute the concrete surface.
• 1,Use the hollow building formwork intersecting surface laid with
15 mm thick.
• 2,Wood square of the distance :
• 1, On the surface of the intersection (spacing: wood square
distance according to the thickness of the slab concrete, in
general, the thickness of less than 0.15 m floor (spacing is 200 ~
• 2,The shear wall (spacing: (spacing according to adjust the
spacing, height and thickness of the wall to wall height of 2800
mm, 300 mm thick wall, for example, using the formwork (15 mm
thickness spacing is 100 ~ 150 mm, if the shear wall, pillar width
more than 1 meter, must add the fixed frame.
• 3, Die shear wall and column puzzle when leaving no gaps,
internal Angle (the bottom of the wall) parts must have wood
square, beam, wall, formwork connection.Shear wall made 4 after the
mold must be assembled into the whole hoisting, then lay flat,
reduce labor intensity, forming effect is good.
• 4, When the nail to the formwork from the formwork edge distance
15 ~ 30 mm, strength wants moderate, nail nails is 40 ~ 50 mm in
length, shoulds not be too long or too short.
• 5,Beam bottom of a piece of wood square must set aside 15 mm seam
allowance, wallboard made on wood square seam allowance, it does
not leak slurry and wallboard material saving.
the products size
cutting and customized are avaliable
|Hebei Mortmain Rubber and Plastic technology Co.,Ltd|
Contact name :Tiffany Jiang
why you choose us
product quality testing report
packing and transportation
contact with me